Pool pump repair when circulation stops
pool pump repair near me
No circulation means cloudy water, algae risk, and an idle heater or salt system. Pumps fail from age, debris, electrical issues, or freeze damage. We diagnose the motor, impeller, and plumbing so you’re not guessing with parts.
What we do
- Troubleshoot power, priming, baskets, and valves
- Repair or replace pumps and related fittings when needed
- Restore flow and confirm the system is circulating correctly
- Recommend maintenance to reduce mid-summer failures
When to call
Call if the pump won’t start, won’t prime, makes unusual noise, or the water isn’t moving even with the timer on.
Questions people ask about this
Straight answers to the questions homeowners and property managers ask most — written so you can act fast in DFW heat, storms, and swim season.
Pool pump is humming but not circulating — what’s wrong?
Often a stuck impeller, capacitor issue, or the motor trying to start against a blockage. Power on with no movement can burn the motor — shut it off and get it diagnosed.
Why won’t my pool pump prime after I cleaned the baskets?
Air in the lid O-ring, a loose union, low water level, or a closed valve. Seat the lid evenly, lubricate the O-ring if needed, and confirm skimmer water level covers the weir.
Is it safe to keep resetting the breaker when the pump trips?
No. Repeated trips usually mean a failing motor, bad wiring, or a ground fault. Keep resetting and you can damage the motor or create a hazard — call for electrical/pump diagnosis.
Can a clogged filter make it look like the pump is dead?
High filter pressure reduces flow and can put the system into a weak-return state. Check the pressure gauge and clean or backwash before replacing the pump.
Variable-speed pump won’t connect to the app — is that a service call?
Often it’s programming, power, or a failed control board — not always the wet end. If the motor still runs from the onboard controls, start there; if nothing runs, treat it as a pump repair visit.
What does it mean if the pump runs but returns are weak?
Restriction on suction or return — dirty filter, clogged impeller, half-closed valve, or a suction-side leak drawing air. Bubbles in the pump lid are a classic air-leak clue.
There’s a burning smell from the pump motor
Shut it off. That’s an electrical/motor distress smell, not a chemistry issue. Running it “one more time” can finish the motor.
The pump lid has cracks and sprays water — emergency?
It’s a real leak and a priming problem waiting to happen. Power off if spray reaches electrics and replace the lid/O-ring soon.
Can a bad capacitor be replaced without a whole new pump?
Often yes on single-speed motors. Diagnosis matters — capacitors are cheap compared with a full wet-end replacement when the motor is otherwise healthy.
After a freeze the shaft seal drips constantly
Shaft seals can fail from age or freeze stress. A steady drip at the seal weep needs service before the bearing takes water.
Related issues
See the full pool FAQ hub or browse pool issues.