Pool leak detection in Dallas–Fort Worth
pool leak detection dallas
A pool that keeps dropping water burns money on fill water and can damage decks and structures. Evaporation is normal; unexplained loss is not. We help isolate whether it’s plumbing, a fitting, or the shell — and get you to the right repair path.
What we do
- Review water-loss history and rule out obvious oversights
- Coordinate leak detection for pool and spa systems
- Support repairs on equipment, lines, and fittings when found
- Document findings for property managers and homeowners
When to call
Book if you’re adding water weekly, seeing wet spots near equipment, or getting higher-than-usual water bills with a full pool.
Questions people ask about this
Straight answers to the questions homeowners and property managers ask most — written so you can act fast in DFW heat, storms, and swim season.
How much water loss is normal from evaporation?
In hot DFW weather, about ¼–½ inch per day can be normal, more with wind and heat. Losing an inch or more daily, or needing frequent refills, points to a leak.
How do I do a bucket test for a pool leak?
Fill a bucket with pool water, set it on a step, mark water levels inside the bucket and on the pool wall. After 24 hours, compare. If the pool drops more than the bucket, you likely have a leak.
Does a pool leak always mean a cracked shell?
No. Many leaks are fittings, valves, pump lids, heaters, or underground plumbing. Start with equipment-pad checks before assuming structural damage.
Why is my spa losing water but the pool isn’t?
Spas often leak at jets, air lines, or the spa bypass. A spa-only drop is a useful clue for leak detection and usually isn’t “just evaporation.”
Can a leaking pool damage my foundation or deck?
Yes over time — especially if water is tracking under decking or toward the house. Unexplained wet spots near the equipment or settling cracks deserve a professional leak check.
Is dye testing something I can DIY?
Pros use dye carefully around fittings and suction points. DIY dye can mislead or stain. If the bucket test fails, schedule leak detection rather than guessing with dye bottles.
My water bill spiked but the pool looks full — could it still be leaking?
Yes. An auto-fill can hide the drop while burning city water. Check whether the autofill is running often and pair that with a bucket test.
I only lose water when the pump is on — what does that mean?
That pattern often points to pressure-side plumbing or equipment leaks that show under flow. It’s a useful clue for leak detection — note it when you book.
The ground is wet near the equipment but the pool level seems fine
Could be a small pad leak, condensation, or irrigation spray. Wipe fittings dry and watch — recurring wetness with the pump on still deserves a check.
Can a bad backwash valve cause water loss?
Yes. A worn multiport can seep to waste even in filter mode. If the waste line runs when it shouldn’t, don’t ignore it.
Do you find the leak and repair it the same day?
Detection and repair are sometimes same-day for simple pad fittings; underground lines may need a follow-up. We’ll tell you what we found before authorizing digs or parts.
Related issues
See the full pool FAQ hub or browse pool issues.